Werbung
Verfügbare Sprachen
Verfügbare Sprachen
View, description
Press the button indicating in the required direction to
operate the motor. When the switch has been activated in
one direction, it cannot simultaneously be operated in the
other direction. Never press both buttons at the same time,
otherwise the switch will be damaged. To reverse the motor,
always reset the first button before setting the switch to the
required position.
Technical data
Use:
For motor-driven
roller blinds
Mains power supply:
230V, 50Hz
Switching capacity:
10A
Temperature range:
0-50degrees
Terminals:
max. 1,5mm
Type of protection:
„For dry rooms"
KN - 321330, 321340 - GB
Roller blind switch / push-button
Art. No. 321330 switch, 321340 Push-button
for motor-driven roller blinds
C
2
1.7.2004/N
Safety instructions
The switch may only be connected to an electrical system
by a qualified electrician in accordance with the wiring
diagrams contained in these instructions. VDE regulations
must be observed, especially in damp rooms. The VDE regu-
lations specify mandatory protective measures. Non-compli-
ance can be dangerous! Installation work and connections
must always be carried out with the system de-energized; for
this purpose, the feeder lines must be disconnected from the
mains on all phases and secured to prevent unauthorized
reconnection. They must be disconnected from the mains
using switchgear guaranteeing a minimum contact spacing
of 3 mm. Ensure that there is no-one in the travel range of
the roller blinds and nothing to obstruct free movement of the
blinds. Compliance with these operating instructions is an
integral part of the device and our warranty conditions.
Wiring diagram
The connections for up and down must be exchanged if the
motor runs in the wrong direction.
�
Rev.-Stand 1
Installation and operating
instructions
Werbung
