fontastic Vita Bedienungsanleitung Seite 5

GB
Pairing
The speaker must be paired with a Bluetooth® device before it can be used for wire-
less music streaming.
1. Turn on the speaker. The voice prompt sounds, indicating that the speaker
is in pairing mode.
®
2. Search for Bluetooth audio devices with your Bluetooth
audio data is to be played.
3. The searching Bluetooth ® device indicates that it has found the „Vita" speaker.
Confirm the pairing with „Vita". A successful connection is confirmed by the
voice prompt.
When using a Bluetooth ® device without display, switch it to pairing mode and wait
a few seconds until the connection with the speaker is established.
Note: If the connection is lost or the transmitter is disconnected for a short
time, the Vita will automatically try to re-establish the connection.
TWS function
The TWS function allows you to connect two Vita speakers together to output your
music through two speakers. To connect two Vita together, turn on both devices, the
devices are in BT mode. Press the
The two devices connect to each other. An acoustic signal indicates a successful
connection.
Press the mode button on one of the speakers twice to terminate the TWS
connection.
Note: The devices do not reconnect automatically after disconnection.
Music playback
Playing music via Bluetooth ®
®
A Bluetooth source must be paired with Vita to receive and output music wirelessly!
Note: The cell phone must support A2DP and AVRCP profile to play and control
music via Vita.
Music control
To play or pause music, briefly press the Play/Pause button
To skip to the next track, press and hold the track forward button
To skip to the previous track, press and hold the track-back button
second.
7
®
device from which
mode button on one of the speakers twice.
.
for one second.
for one
Radio mode
To enter radio mode, press the Play/Pause button
the unit is on. In radio mode, press the Play/Pause button
search the receivable radio stations. After the search is finished, you can switch bet-
ween the stations by pressing the
Press the Play/Pause button again for about 2 seconds to switch to BT or Card mode
(only with SD card inserted).
Note: The TWS function is not supported in radio mode. After switching to
BT or Card mode, the TWS connection must be re-established manually.
Playback from Micro SD card
1. Place a Micro SD card in the card slot (8) of the Vita with the contacts facing up.
2. The card mode starts automatically and the music is played. Press the Play/Pause
button for two seconds to switch between BT, Radio and Card mode.
Note: You need to insert a Micro SD card to change the mode. When the speaker
is turned on, it will automatically start in BT mode.
Hands-free function
With a built-in microphone (2), the speaker is suitable to be used as a hands-free
speaker for phone calls in BT mode.
Note: At high volume, feedback with the microphone may occur.
This results in echo on the phone side, not on the speakerphone side.
Accepting/ending/rejecting calls
To answer an incoming call, press the
To end an ongoing call, press the
To reject incoming calls, press and hold the
The call will be rejected.
Redial, press the On/Off button twice while no call is in progress.
The last dialed number will be called again.
RGB lighting
Vita is equipped with 360° RGB lighting. By briefly pressing the light button
scroll through the different light modes. By pressing the button again, the lighting is
switched off.
Volume adjustment
Increase volume: Press the volume+ key
reached.
Decrease volume: Press the volume- key
reached.
for about 2 seconds while
twice to automatically
or keys for 2 seconds.
power key once.
power key twice.
power key for one second.
repeatedly until the desired volume is
repeatedly until the desired volume is
GB
you
8