Magmaweld EXPERT-Serie Bedienungsanleitung Seite 28

28 Operation
PAGE 5
EN
The starting current will be determined. It will operate as a percentage of the main current. It will be active
a) STARTING C. (STARTING CURRENT)
when 6 trigger mode is selected. Even though it allows setting for other modes, it will not work.
• %0-200
Setting Range
Start time will be set. It will be active when 6 trigger mode is selected. Even though it allows setting for other
b) STARTING T. (STARTING TIME)
modes, it will not work.
• 0-5 sec.
Setting Range
Finish Current will be determined. It operates as a percentage of the main current. It will be active when 6
c) FINISH C. (FINISH CURRENT)
trigger mode is selected. Even though it allows setting for other modes, it will not work.
• %0 - 200
Setting Range
The finish time will be set. It will be active when 6 trigger mode is selected. Even though it allows setting for
d) FINISH T. (FINISH TIME)
other modes, it will not work.
• 0-5 sec.
Setting Range
USER MANUAL
EXPERT SERIES
www.magmaweld.com