Bearing Capacity; Tartup; Installation, Factory Crane; Bleeding The Crane - Chicago Pneumatic CP9620 Bedienungsanleitung/Sicherheitshinweise

2.1- Bearing capacity

The bearing capacity of the crane always depends on the set arm length. The table shown in 4.2 shows the bearing capacity of each crane
depending on the arm length.
3- Starting operation
Please read the "Safety precautions when using the crane" in point 7 carefully.

3.1- Installation, factory crane

For installing the crane, proceed as follows:
When lowering or folding the chassis, the wheels must generally be oriented as shown in ill. 1.
1
illustration
Lowering the chassis (for security reasons this procedure should be carried out by 2 people.)
Remove the bolt (position 18) by pulling out the spring cotter pin (position 19).
Pull the bolt out now. The crane must then only be tilted backwards slightly, in order to relieve the wheels (position 12).
Fold the chassis into a horizontal position (don't reach with your fingers into the fulcrum), and align the hole on the
chassis with the hole on the frame (position 01). Secure the chassis again with the bolt and the spring cotter pin.
(ATTENTION: DANGER OF CRUSHING)
OK
•
Folding the chassis (for security reasons this procedure should be carried out by 2 people.)
Slightly tilt the crane backwards. Loosen the bolts as described above, and fold the chassis upwards. Secure it with the
bolt..
The crane can then be set on the transport wheel and transported to another location.
(ATTENTION: DANGER OF CRUSHING)
NO

3.2- Bleeding the crane

Before using the crane for the first time, while the lifting arm is lowered, turn the hand wheel of the hydraulic unit counter-clockwise, while at the
same time pumping several times with the handle. Then, release the hand wheel. The hydraulic system should then be bled..
4- Working with the crane

4.1- Lifting and lowering a load

With this crane, the load is lifted by pumping the pump lever (position 31) several times.
To lower the load, the hand wheel of the hydraulic unit of the crane must be turned counter-clockwise..
ATTENTION: It is strictly forbidden, to stand under raised loads.

4.2- Setting the arm length

To set the arm length, please proceed as follows:
•
Move the boom (position 20) in a position that you can reach (lifting/lowering).
•
Remove the spring cotter pin and pull the bolt out of the boom (position 20).
•
Set the boom to the desired position.
•
Insert the bolt into the boom (position 20) again, and secure it with the spring cotter pin.
VARIABLE EINSTELLUNGEN / CAPACIDAD VARIABLE / VARIABLE
CAPACITY / CAPACITÉS VARIABLES
3
POSITION / POSICION / POSITION
MOD 1
CP9620 1000 kg 750 kg
Follow the same procedure for the other leg.
2 1
2 3 4
500 kg 250kg
IMPORTANT! Always pay attention to the permissible load for the position.
A diagram with the permissible bearing capacity for each position is
attached to the crane.
- 10 -