Noise/Vibration Information; Technical Data - Kress 900 WTSE Bedienungsanleitung

900 WTSE - Buch Seite 9 Donnerstag, 28. Juni 2001 2:52 14
900 WTSE
Always store grinding discs such that they are pro-
tected against damage.
Before placing the machine down anywhere,
switch it off and wait for it to come to a standstill.
The grinding tools continue to run a little after
switching off.
The mains receptacles in the working area must
be protected by a residual current circuit
breaker (RC).
Do not drill holes into the housing to label the
machine. The protective insulation will be bridged.
Please use self-adhesive labels.
3

Noise/vibration information

Measured values determined according to EN 50 260.
Sound pressure level:
Sound power level:
Work place emission value:
For operation, noise protection measures are
required.
The acceleration measured is usually less
2
than als 2.5 m/s .
4

Technical Data

Angle Grinder
Article number
Input power
Output power
No-load speed
Speed under load
Grinding discs Ø
Cutting depth
max. peripheral velocity for
roughing and cutting discs
Disc chucking bore
Grinding spindle thread
Weight
Safety class
5
1 ON/OFF switch
2 Latch for mains cable module
3 Ventilation slots
4 Auxiliary handle
5 Protective guard
6 Roughing/cutting disc
7 Clamping flange
8 Quick-lock nut
Not all of the accessories illustrated or described are
included as standard delivery.
6
Before any work on the machine itself, pull the
82.5 dB (A)
mains plug!
95.5 dB (A)
85.5 dB (A).
Assembling the auxiliary handle
Place the clamping strap around the gearhead and
insert it in the openings on the clamping part of the
auxiliary handle. The auxiliary handle is locked by
turning it clockwise. In so doing make sure that the
notches on the supporting part grip in the groove on
the machine housing.
Adjusting the auxiliary handle
900 WTSE
By turning the handle anticlockwise, the fixture is
06 05 1401
unlocked. The auxiliary handle can be turned to the
900 Watt
required position. By turning the auxiliary handle
490 Watt
clockwise, it is locked again.
9500 RPM
Connect the mains cable module to the handle. The
7500 RPM
plug must latch.
max. 125 mm
Use the mains cable module provided only for
max. 32 mm
Kress Electro-Tools. Do not attempt to operate
other machines with the module.
80 m/s
Only use original Kress mains cable modules and at
Ø 22 mm
least flexible rubber tube (code designation
M 14
H05 RR-F).
approx. 1.75 kg
II/
Illustration
Mounting the Auxiliary Handle and
the Mains Cable Module
English
9