In-Place Sanitization; Routine Maintenance - Vollrath STOELTING SCBA118-37 Bedienungsanleitung

S B C A & S C B F
7 For cold drink dispensing or cleaning, install the Cold Drink
Restrictor (BR0313). To install remove the condensation ring,
clip the cold drink restrictor on the end of the spigot. To remove
or disassemble place thumb on cold drink restrictor tab and
lightly pull down to remove.
figure 22
figure 23

6. 5 IN-PLACE SANITIZATION

NOTE: Sanitizing the assembled device, prior to putting
into service, should only be performed, if neces-
sary, as an additional precaution to the sanitization
of the disassembled devices described previously,
never instead of it.
1 Prepare a solution of water and sodium hypochlorite
(bleach) at a ratio of 2 tablespoons per one gallon of water.
2 Pour the solution into the containers.
3 Using a suitable brush, wipe the solution onto all parts
above the level of the solution and on the underside of the
cover.
4 Install the cover and operate the dispenser to allow the
solution to be stirred for about 2 minutes. Drain the sanitizing
solution from the bowls through the spigots and then dispose of
it.
5 Remove the flow restrictor from the container (see figure
13).
6 Rinse using a cool water in order to eliminate any remaining
sanitizing solution from the bottom of the containers. Do not
perform further rinsing.
6. 6 FREEZE DOWN & OPERATION
1 Place a container under the spigot and rinse the bowl with
mix to flush out any remaining sanitizing solution.
2 Fill the bowls with chilled mix.
3 Turn on the main power.
4 Press the power/standby button then press and hold the
freeze button for 1 second to start freezing product.
5 Once freezing, the snowflake icon displays on the screen
and the density bars are displayed.
6 Momentarily press the freeze or clean button to increase or
decrease density.

7 ROUTINE MAINTENANCE

1 Every day: Inspect the dispenser and check for leaks of
product from the gaskets. If you notice leaks, first make sure
that the components of the dispenser are properly installed,
then check that the gaskets do not require lubrication and
finally that they are not worn or damaged. If they are worn,
replace with original replacment parts from the manufacturer.
2 Every month: Remove the dust from the condenser filter
on the back of the machine (see figure 24).
12