Clatronic MPS 2633 Bedienungsanleitung Seite 27

43426-05-MPS 2633
Summary of the individual parts
1 Nail filing disk, fine (for the fine filing of thicker and harder nails)
2 Brush for nail cleaning
3 Callus file cone, fine (to gently remove hard skin and callouses)
4 Callus file cone, coarse (to quickly remove hard skin and callouses)
5 Conical file, pointed (for the corners of toenails)
6 Conical file, blunt (for the corners of toenails)
7 Polishing cone (for a final polishing of the nails)
8 Device to push back the skin from the nails
9 AC adapter/charger and storage compartment (in the bottom)
10 Case for the entire set
11 Nail drying area
12 Nail drying key
• Remove the charger from the compartment under the device.
• Charge the battery in the drive unit "See "Charging the battery")
• Attach the desired accessory onto the shaft. You can attach or remove the
accessories by simply pushing them onto the shaft of the drive unit or pulling
them off.
• Now insert the plug of the mains adapter into a 230 V / 50 Hz mains socket.
Please note: do not bathe your hands or feet and do not spread cream on them
before the treatment. Just wash them at the end of the treatment.
1. Turn on the unit by means of the switch located at the top of the handle. The
device has 2 speeds (0–1–2).
2. Guide the accessory to be used with a gentle movement over the place to be
treated. Constantly check at brief intervals the progress of the treatment to
avoid injuries.
Connect the AC adapter to the bottom right hand of the device.
Connect the AC adapter to a 230V/50Hz socket.
Lay your hand with the nails to be dried in the cavity of the casing and press the
key down with the palm of your hand. The hot air jet is started. When the nails are
dry, take your hands out of the cavity and remove the AC adapter.
03.06.2004 12:04 Uhr
Starting up
Use
Nail drying function
Seite 27
27
GB