Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB Installation and operating instructions
LED Panel
501400
Art. No.
These operating instructions belong exclusively to the above-mentioned product. It contains important information on the commissioning
and handling of the luminaire. Therefore, please pay attention to these operating instructions, even if you pass this product on to third
parties. It is therefore important that you keep these instructions in a safe place for future reference.
.
Introduction
Dear customer, thank you for purchasing our product. You have purchased a product from Vollmer, which has been built according to the
current state of the art. The luminaire meets the requirements of the applicable European and national directives. In order to maintain the
condition of the product and to ensure safe operation, you as the user must observe these operating instructions!
.
Safety instructions
In case of damage caused by non-observance of these operating instructions, the warranty claim expires!
We accept no liability for consequential damage!
If the luminaire is damaged, it is strictly forbidden to use it.
Do not allow children to play unsupervised in the area of the luminaires or other electrical devices.
Do not bring the luminaire into contact with extreme heat or open flame.
Do not modify or alter the entire product. Modifications to the luminaire will void the warranty.
The type plate must not be removed.
The luminaire is designed for indoor use and may:
only be operated with 230V ~50Hz and connected according to protection class II (two).
o
o
only be operated on a stable, level surface.
only be operated on normal or non-flammable surfaces.
o
not be exposed to strong mechanical stresses or heavy soiling.
o
.
Before installation/commissioning
The luminaire may only be operated outside its packaging.
Carefully remove the luminaire from its packaging.
Before operating the luminaire, make sure that it has not been damaged during transport. If there is any damage to electrical parts, the
lamp must not be operated. Repairs may only be carried out by a qualified electrician.
Keep packaging material away from children and pets. Danger of suffocation!
.
Installation/Commissioning
This product may only be installed by a qualified electrician.
Before installation, the building-side connection lines must be disconnected from the power supply and secured against being switched
on again.
Remove the cover cap from the 230V side of the ballast unit.
Now connect the connecting cables of the building installation to the ballast unit. Connect the phase, usually the brown or black cable,
to the terminal marked "L". The blue cable must be connected to the terminal "N".
Screw the cover cap of the 230V side of the ballast back on.
Place the panel in the ceiling
Make sure that cables are not severely bent, crushed or pinched, and that all parts of the luminaire are not subjected to mechanical
pressure.
Switch the fuse back on after completing the work.
.
Malfunctions
Luminaire does not switch on
Light switched on at the switch?
Check the connected lines
.
Technical data
Article
Connection
501400
230 V 50 Hz
This product contains a light source of energy efficiency class D
.
Care
First disconnect the entire product from the power supply and allow it to cool down before carrying out any cleaning or maintenance
work on the product.
Clean the product regularly - only with a slightly damp, soft and lint-free cloth.
.
Disposal
Waste electronic equipment must be taken to public collection points and must not be disposed of as household waste.
H. Vollmer GmbH ǀ Allmendring 29 ǀ 75203 Königsbach-Stein ǀ www.HEITRONIC.de
LED
35 W, 4200 lm, 4000 K
Lamp not replaceable
Protection type
Protection class
IP40
II
2 / 4
10/22
Werbung
