Getting Started; Charging The Lithium Battery; Using An External 12V Battery - Spypoint LINK-MICRO-S-LTE Anleitung

Getting started

CHARGING THE LITHIUM BATTERY

•
Remove the lithium battery pack from the camera.
•
Using the Micro USB cable, recharge the battery pack for about 12 hours.
•
Once the lithium pack is fully charged, the red light will turn green.
Do not insert AA batteries into the lithium battery
compartment, as this could damage the camera.
HOW YOUR CAMERA USES SEVERAL POWER SOURCES
1.
Your camera's main source of power is the lithium battery pack (#LIT-10, included)
and offers longer battery life, roughly doubling that of standard AA batteries.
•
The solar panel's sole function is to recharge the lithium battery and will
operate when solar energy is detected.
•
When the lithium battery pack power level becomes insufficient, the
camera shuts down.
•
The solar panel will continue recharging the lithium battery pack until the
power level is sufficient. At this point, your camera will automatically turn
on and resume with your configured settings.
2.
Moreover, the camera was designed to recognize and use a primary power
source other than the lithium battery pack:
•
As soon as you plug an external 12V battery (#BATT-12V, sold separately)
into your camera, it becomes your camera's new primary power source.
The lithium battery pack will only be used once the 12V battery is depleted.
•
Simply plug the 12V cable into the 12V jack of the camera and connect the
other end to the 12V battery.

USING AN EXTERNAL 12V BATTERY

•
Using an external 12V battery source does not recharge the lithium battery pack.
•
The solar panel will not recharge an external 12V battery.
4