First Time Use - Outsunny B30-005 Montageanleitung

EN
Step 1: Assemble the poles with by connecting B between the 3 pole
sections with pole attachments C. Secure the pole pieces with the pole
attachments together.
Step 2: Insert the assembled pole into the opening at the top of the
mounting base.
Step 3: Attach assembled light head over the top of the assembled pole to
complete installation.

FIRST TIME USE

Step 1 : Move the pull tap .Slide the ON/OFF switch to the ON position.
Step 2: Your solar light will then automatically switch on at dusk and
charge during daylight hours.
INSTALLATION
This light can be installed in soft ground or into a hard surface
SOFT GROUND INSTALLATION
Step 1: Locate an area where you wish to place the light and insert stake
into the ground. Insert stake leaving approximately 10cm length above the
ground's surface. If the ground is hard, soften by soaking area with water
first or gently tap the stake into the ground using a rubber mallet.
Step 2: Remove mounting base from the bottom of the assemble pole and
gently place light down.
Step 3: Attach mounting base over the centre of the installed ground stake.
Step 4: To complete installation, re-attach the assembled solar light into
the opening at the top of the mounting base.
HARD SURFACE INSTALLATION
Step 1: Remove mounting base from the bottom of the assembled pole and
gently place light down.
Step 2: Using a pencil place marks through the 3 holes located around the
edge of the mounting base.
Step 3: Remove the base from position and drill a hole at the 3 points
marked, large enough to fit the plastic anchors inside.
NB: Before drilling holes, it is recommended that you first check the
light effect at night to ensure you are happy with the position yo have
chosen for installation. Be sure to also check that the location will
receive direct sunlight each day to charge the battery.