Resetting To The Factory Default Settings - Axis Communications 240Q Installationsanleitung

Page 12
Accessing the Axis Video Server from the Internet
Once installed, your Axis Video Server is accessible on your local network (LAN). To access the
video server from the Internet, network routers must be configured to allow incoming traffic,
which is usually done on a specific port. Please refer to the documentation for your router for
further instructions.
For more information on this and other topics, please visit the Axis Support Web at
www.axis.com/techsup

Resetting to the Factory Default Settings

This will reset all parameters, including the IP address, to the Factory Default settings:
1. Disconnect power from the Axis Video Server.
2. Press and hold the Control button and reconnect power.
3. Keep the button pressed until the Status Indicator displays yellow (this may take up to 15
seconds), then release the button.
4. When the Status indicator displays green (which can take up to 1 minute) the Axis Video
Server is reset to the factory default settings.
5. Re-install the Axis Video Server using one of the methods described in this document.
More information
For more information, please see the Axis Video Server User's Manual, which is available on
the CD included in this package. Updated versions can be obtained from www.axis.com
Get user manuals: See SafeManuals.com
Axis Video Server Installation Guide