Driving Operation - Lindinger ABSIMA FUN MAKER Bedienungsanleitung

DRIVING OPERATION:

Steering Trim and Speed Switch:
Use Steering-Trim to adjust the vehicle's straight run.
To do this, drive slowly away from you and turn the
control knob until the vehicle goes straight.
Use the Speed Switch control (throttle trim) to reduce
the top speed of the vehicle.
FIRST DRIVE:
1 . Switch on the transmitter (1). The
red LED starts blinking.
2. Connect the battery with the car and
switch on (2). The connection
process takes place and the LED
lights up constantly.
3. Carefully test throttle/brake and
steering and make any necessary
trim adjustments before driving.
4. Exit: first turn off the car and then
turn off the transmitter.
5. Disconnect the battery from the car.
AFTER THE DRIVE...!
After using your vehicle, you should perform the following maintenance tasks on a regular basis:
Check your car for obvious damage and repair it before the next use.
Check the vehicle for loose bolts/nuts and tighten them after each ride.
Check the wiring, connectors and battery for damage.
Check the steering servo. If accurate steering trim is no longer possible, the servo must be replaced due
to wear.
Clean the vehicle completely and remove any moisture to prevent corrosion.
Remove batteries from transmitter and vehicle when not in use.
TIP: In the beginning, set the Speed Switch
to slow speed to get used to the vehicle.