KRATOS SAFETY FA 20 100 Serie Bedienungsanleitung Seite 8

VERIFICATION:
Service life of the product is 10 years (in accordance with the annual examination by a competent person authorized by KRATOS SAFETY), but it
may be increased or reduced according to use and/or the results of the annual inspections. The equipment should be inspected if there is any doubt, or
following a fall, and at least annually, by the manufacturer or a competent person* and in strict compliance with the manufacturer's periodic inspection
procedures (and in particular the inspection guides ref. GI XX-XXXXXX-XX) to check its strength and therefore the user's safety.
*: refer to the definition of a competent person on our website under: Info/Technical Advice.
The product data sheet should be completed (by writing) after each verification; date of inspection and date of next inspection must be indicated on the
data sheet, it is also recommended to put date of next inspection on the product.
SERVICING AND STORAGE; (Comply strictly with these instructions)
During transport, keep the product in its packaging, well away from any cutting surface; clean it with water, wipe it with a rag and hang it up in a well-
ventilated location, to let it dry naturally and away from a naked flame or heat source; follow the same procedure for components that have become damp
during use. The system must be stored in its packaging in a dry, well aired place protected from extremes of temperature.
8