Safety Information - KYONE Advance Pro Bedienungsanleitung

• Remove any comb attachments if in use.
• Remove hairs and dirt from the hair clipper
using the cleaning brush.
The button to adjust the length of the
cutting head should be turned fully down
at 2,0 mm.
Carefully take the cutting head from the device,
by pushing with 2 hands at the top of the cut-
ting head. Remove the hairs from the cutting
head with the supplied brush. Oil the cutting
head: with regular use of the device we recom-
mend to do this daily. Oil the cutting head daily
with 5 small drops of oil. All drops should be
applied on the exact specified places.
Only use special oil that came with the machine
(do not dilute, it does not bother the running of
the machine).
Turn the button to adjust the length of the
cutting head again fully down at 2,0 mm. First
place the bottom part in the device. this should
fit perfect. Only after that push the top of the
cutting head in the machine. If you feel too
much resistance do not use excessive force, to
prevent any damage. Instead do the procedure
again and see if you have properly followed the
instructions.
• Please use a damp cloth to clean the housing
and the charging station.
• Do not use aggressive or abrasive cleaners.
The cutting head may be replaced should its
cutting performance start to fade over time
(available as a spare part).
Troubleshooting / when the hair clipper
doesn't work...
• The clipper isn't working or can't be
switched on?
Is the battery empty? Please place the clipper in
the charging station (connected to the mains)
or connect the mains adapter directly to the
clipper. You may also continue to work with the
power cable connected.
Please check the power supply for the correct
mains voltage.
• The hair clipper switches itself off.
Please charge the clipper's battery or continue
with the power cable connected.
• The hair clipper is "pulling"?
Please clean and oil the clipper regularly,
preferably daily when it is in frequent use.
Please proceed as described above.
• Skin damage
Did you apply too much pressure with the
clipper? Reduce the pressure applied.
Damaged cutting head? Check the cutting head
for damage or irregular running. Replace the
cutting head if necessary.

Safety information

• This hair clipper is intended solely for profes-
sional use.
• The appliance may not be opened.
• Never attempt to remove dust or dirt with
the help of pointed objects, such as needles or
comb tips, from the hair clipper's interior.
• The mains adapter may only be connected
to alternating currents. Please check whether
the mains voltage corresponds to the voltage
indicated on the mains adapter's type plate.
• Do not immerse the clipper, mains adapter
or connecting cable in water and do not rinse
under running water.
• No fluids may be allowed to get inside the
clipper.
• Do not use this clipper in proximity
to bathtubs, showers, wash basins
or other vessels containing water
and do not use it when your hands
are wet.
• Should the clipper have fallen into water,