Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Montage-/ Betriebsanleitung
Mounting-/Operation Instruction
EN
Congratulations on your purchase of this nobilé-product!
You have decided on a high-quality product which is manufactured with the utmost care and subject to several quality controls. Safe use of the
product is only guaranteed if each instruction is followed accordingly. In case of damage caused by non-observance of these instructions the warranty
expires. The installation and electrical connection must be done by an authorized expert (e.g. electrician) in compliance with existing standards and
local code. Prior to any installation or maintenance work, mains must be disconnected. Before putting in operation, make sure any component of the
entire installation does not bear a risk of life. According to common practice, please perform a standard function test, before installing. To make
maintenance work possible, the lighting system should be accessible after installation (auditable).
Technical Specification
Power Supply
Operation Frequency
Transmission Power
Detection Range
Installation height
Ambient Temperature Ta
Mounting:
Warning!
1.
The sensor has a warm up time of 15 seconds after the switching on the lamp. At this time the lamp will be at full bright.
2.
Default factory setting: Sensitivity-100%, Hold-time-5min., Daylight sensor - Off, Stand-by dim level - 30%, Stand-by time - 60 min.
3.
The lamp will switch On and Off to confirm a change made through the remote control.
Motion Sensor
with sufficient natural light, the
lamp will not switch-on even a
presence is detected
Daylight Sensor
with insufficient natural light, the
sensor will switch the lamp ON
when a presence is detected
Präsenzmelder für LED Hallenleuchte F400-SI
Presence detector for LED High Bay F400-SI
12V – 24V DC
5,8GHz 75MHz
<0,2mW
max. 8m radius
max. 15m
-20 ~ 60°C
with insufficient natural light, the
sensor will switch the lamp ON
when a presence is detected
with sufficient natural light, the
lamp will not switch-on even a
presence is detected
Technische und gestalterische Änderungen im Zuge stetiger Produktentwicklungen vorbehalten.
Technical and design changes due to product developments are subject to change without prior notice.
nobilé AG – Wächtersbacher Str. 78 - 60386 Frankfurt/M. Germany - www.nobile.de
After the set Hold-time, the lamp
will dim down to the set Stand-by
level when no presence detected
rev. 0.1 – 29.04.2022
Seite 2 von 2
The
lamp
will
switches
off
automatically after the Stand-by
time elapses
Werbung
