Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. Set the timer to the desired heating time.
à
The fan will start working and the power indicator POWER will light up to indicate the
product is in operation.
à
During heating process the ready light READY will turn on/off because the heating
element is being switched on/off to maintain the set temperature.
à
Some food requires shaking halfway through the cooking time (see "cooking chart").
Pull the frying tank out by the handle and shake it. Then slide the drawer back inside.
6. A bell will sound when the heating time has elapsed.
7. Remove the frying tank and place it onto a suitable heat resistant surface.
11.3.1 Cooking tips
■
Cooking times may be affected by the size of ingredients (e.g. smaller sizes require
shorter cooking times).
■
A light brushing of olive oil or vegetable oil over ingredients works well for air frying.
■
Brush potatoes in oil before cooking to get a crispy result.
■
Always pat food dry before cooking to encourage browning and to avoid excess smoke.
■
The optimal amount of potato for preparing crispy fries is 400 grams.
■
Place a baking tin or oven dish in the frying tank if you want to bake a cake, quiche, or
protect fragile ingredients.
■
To reheat food, set the temperature to 150 °C for up to 10 minutes.
■
Do not overfill the frying tank (e.g. more than 2/3 full).
■
Some foods need to be shaken vigorously or turned over during the cooking time. See
"cooking chart".
■
To avoid excess smoke when cooking naturally high fat foods (e.g. chicken wings, saus-
ages) it may be necessary to empty fat from the frying basket between batches.
■
Cook breaded ingredients in small batches. Pressing the breading onto the surface helps
it adhere.
■
Encourage air flow around all surfaces by arranging pieces so that they are not touching
each other.
11.4 Overheat protection
If the temperature gets too hot, the overheating protection system will trigger and shut the
power OFF.
If this happens:
1. Disconnect the product from the power supply.
2. Allow the product to cool down completely.
3. Reconnect the product to the power supply.
4. Resume use.
12 Troubleshooting
Problem
Solution
■
Product does not
Check the power supply.
switch on
■
Turn the timer/power dial to the required cooking time.
■
Ingredients not
Cook smaller batches of ingredients.
fully cooked
■
Increase the time and/or temperature setting.
■
Uneven frying
Ingredients that overlap each other (e.g. fries) should be shaken
halfway through the preparation time.
■
French fries should be pre-soaked and dried (e.g. strained and pat
dry using kitchen towels) before cooking.
■
Food not crispy
Check that the ingredients are suitable for oven cooking.
enough
■
Brush a light coating of oil over the ingredients.
■
Fries may need to be cut into thinner pieces
■
White smoke is
Oil from greasy ingredients will leak into the pan. When oil heats up
coming out
white smoke is emitted. This does not affect the product or the res-
ult.
■
Remove excess oil between the frying tank and cooking tray after
each use.
13 Cleaning and storage
13.1 Cleaning
Important:
– Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions.
They damage the housing and can cause the product to malfunction.
– Do not immerse the product in water.
– The product, frying tank, and cooking tray are not dishwasher safe.
1. Disconnect the product from the power supply.
2. Remove the frying tank to help the product cool down faster.
3. Let the product cool down to ambient temperature.
4. Wipe the outside of the product with a damp cloth.
7
5. Clean the drawer and grill plate with hot water, washing-up liquid, and a non-abrasive
sponge.
Tip:
If dirt is stuck to the bottom of the drawer, fill the drawer with hot water with some wash-
ing-up liquid. Allow to soak for approximately 10 minutes.
13.2 Storage
The product should be cool, clean, and dry before storage.
14 Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste. At the end of its service life, dispose of the product in accord-
ance with applicable regulatory guidelines.
You thus fulfill your statutory obligations and contribute to the protection of the environment.
15 Technical data
Input .............................................. 220 – 240 V/AC, 50 – 60 Hz
Rated power .................................. 1300 W
Temperature range........................ approx. 140 – 200 °C
Capacity......................................... 1.5 L (with rack)
Protection ...................................... Overheat
Timer ............................................. max. 30 mins
Operating temperature ................. -10 to +55 °C
Operating humidity ....................... 0 - 85 % RH
Storage temperature ..................... -18 to +40 °C
Storage humidity ........................... 0 - 85 % RH
Cable length .................................. approx. 95 cm
Dimensions (W x H x D) (approx.)
Weight (approx.) ........................... 2850 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in
electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited.
This publication reflects the technical status at the time of printing.
Copyright by Conrad Electronic SE.
*2389920_V2_1121_dh_mh_en I2/O2
1.8 L (without rack)
240 x 320 x 290 mm
Werbung
