Herunterladen Diese Seite drucken

Pedalo Safety Anleitung Seite 2

Rollbrett

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Manual
20161005 nature colored
20161001- 20161004 + 20161006 colored
Pedalo® Scooter Board 'Safety'
Before using the device for the first time
(or before starting with assembly),
please read instruction completely and keep it.
Important information and warning hints:
Warning!
The Pedalo® Scooter Board 'Safety' is to be used with caution, since it requires great skill, so as to avoid falls or collisions
causing injury to the user or third parties. In case of doubt first use the device only with assistance and/or appropriate protective
equipment.
Warning!
To be used only under the direct supervision by an adult.
Warning!
Collisions with other scooter boards or obstacles must be avoided. Risk of head or finger injuries.
Warning!
Riding in standing position requires special care and concentration.
Warning!
Using your fingers to push the board, never do it in the range of rolls. High danger of crushing!
The roller boards should be used on flat and smooth floor coverings in the interior.
Do not drive on edges or over higher ledges/levels etc. The rolls could be damaged.
Warning!
The packing is not part of the product and have to be disposed.
Keep plastic bags and films out of the reach of babies and young children – RISK OF SUFFOCATION!
After longer or frequent use, check that the screws are tight and retighten if necessary.
Defective and worn parts should be replaced by original replacement parts immediately.
The product is made of natural birch wood. Differences in color, structure, grain, small included knots or scars, prove the genuineness
of the material and therefore show no reduction in quality.
Maintenance and cleaning:
Protect item for damp and wet.
This device is meant for using from persons at the age of 3 up.
Mounting the rolls:
At first insert the wheel bolt from above in the board.
Use a rubber hammer to knock the square of the screw slightly into the wood so that
the screw cannot turn during assembly. Now you can mount the roll from below. To
this put the roll on the screw, place the flat washer and the nut and then use the
supplied tubular hexagon box wrench to fasten the roll by tightening firmly until...
...the screw head accurate fits on the board without any gap.
Holz-Hoerz GmbH
Dottinger Str. 71
D-72525 Münsingen
Tel. +49 (0) 7381 - 9357 0
Fax +49 (0) 7381 - 9357 40
info@pedalo.de
www.pedalo.de
Maximum weight capacity approx. 150 kg

Werbung

loading

Diese Anleitung auch für:

20161005201610012016100420161006