FEIYUTECH Feiyu Pocket 2 Kurzanleitung Seite 29

4. Un fonctionnement continu prolongé peut entraîner la hausse de la
température superficielle du produit, veuillez manipuler avec prudence.
5. La chute ou la collision du produit peut l'endommager et provoquer un
fonctionnement anormal. En cas de dysfonctionnement à cause de la chute ou
collision, veuillez contacter le service après-vente Feiyu.
Stockage et Entretien
1. Gardez à l'écart des enfants et des animaux domestiques.
2. NE laissez pas le produit à proximité d'une source de chaleur (four ou
réchauffeur, etc.) ni le placez à l'intérieur d'un véhicule lors des journées chaudes.
3. Veuillez le stocker dans un environnement sec.
4. NE surchargez ni surutilisez la batterie, sinon cela endommagera le noyau de
la batterie. Pendant une période de non-utilisation prolongée, il est recommandé
de le recharger au moins une fois/mois.
5. N'utilisez pas le produit dans un environnement à température trop élevée ou
trop basse.
FCC regulatory conformance:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause
undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE
The manufacturer is not responsible for any radio or TV interference caused
by unauthorized modifications to this equipment. Such modifications could
void the user's authority to operate the equipment.
RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.