Technical Data - Jula Anslut 018971 Bedienungsanleitung

The product must be discarded
if the glass front is cracked or
damaged.
Recycle discarded product
in accordance with local
regulations.

TECHNICAL DATA

Rated voltage
Output
Protection rating
Luminous flux
Colour temperature
Cord length
DESCRIPTION
1. Floodlight
2. Assembly screw
3. Lock ring to adjust height
FIG. 1
USE
1. Fold out the stand legs.
2. Undo the lock ring and adjust to the
required height on the stand.
3. Tighten the lock ring.
4. Place the work light at a safe distance
from the nearest object. Align the light
source in the required direction.
5. Plug the plug into a power point.
The light
source is not
replaceable.
Non-replacable
control gear.
230 V ~ 50 Hz
20 W
IP65
2000 lm
4000 K
2.5 m
MAINTENANCE
RECYCLING
Recycle end-of-life product in accordance with
local regulations. The light source should
be removed from the lamp and recycled
separately. See description of method below.
1. Undo the nuts and screws between the
stand and floodlight by hand.
2. Cut the top corner of the floodlight
housing with a hacksaw.
FIG. 2
3. Insert a flat-tip screwdriver in the gap
between the glass and the casing, and
carefully pry both parts apart. Stick
another screwdriver between the glass
and the casing and carefully bend apart.
Continue along the edge round the lamp
until the glass comes loose.
FIG. 3
4. Lift off the glass to access the LED light
source.
FIG. 4
5. Remove the light source.
EN
11