Spralla 3D Pen 2 Anleitung

Temperature tuning
Normally the filament output should be smooth
without bubbles.
Temp. - Temp. +
196
Increase the temp if:
Output filament surface color looks dim and dark.
Motor sounds strained.
Decrease temp if:
The nozzle has crackling sound.
The filament comes out with bubbles.
Trouble shooting
Symptom Action
Possible causes
Power adapter Replace power
LED Power on
or cord fault adapter or cord
does not lit
Replace the
Circuit board fault
circuit board
Replace the
Nozzle blocked
nozzle parts
No filament
Temp too low Increase temp
coming out
from nozzle
Wrong type of Check filament
filament type: ABS or PLA
Wrong size of Check filament
filament size: 1,75mm
Filament
failed to load
Filament end not Cut the filament
flat end and reload
No heating Heating coil
Replace the
damaged
nozzle parts
Working angle
>65°
What is PLA and ABS?
PLA is a type of polyester made from fermented
plant starch from corn, cassava, maize, sugarcane
or sugar beet pulp. The sugar in these renewable
materials are fermented and turned into lactic
acid, when is then made into polylactic acid, or
PLA.
ABS filament is one of the most common
materials used in 3D printing today. ABS, or
Acrylonitrile Butadiene Styrene, is a thermoplastic
that is easily molded when heated and hardens
evenly when cooled. ABS is made from monomers
Acrylonitrile, 1,3-Butadiene and Styrene with
petroleum as the basis.
Marking of product
CoolStuff AB
3D PEN 2
Donaugatan 2
18763
211 20 Malmö
Input:5V DC
Fila.dia 1,75mm
www.coolstuff.com
Made in China
+46 40 187200
info@coolstuff.se
Manual
3D- pen
3D Pen 2 18763
EN
Rev. 01 © Copyright 2022 CoolStuff AB