Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OCH 110 / 115 / 120 / 125 / 130 / 150
SAFETY INSTRUCTIONS
Read this manual carefully and completely before you start the installation. This product is
not intended to be used by children or persons with limited mental or motoric capabilities.
The product must be secured against such use. The use of this product is only allowed in
the way described in the section „description and function". Do not expose the product to
heat or moisture.
Not attending to the safety instructions may result in injury and/or property damage.
DESCRIPTION AND FUNCTION
This hybrid cable allows the transmission of UHD signals.
INSTALLATION
1. The hybrid cable dispose of a fixed direction: input side („Source") and output side
(„Display").
2. The input side must be connected to the signal source (e.g. Bluray), the output side to a
playback device (e.g.TV).
3. The hybrid cable dispose of a HDMI plug type D at both ends, each with an adapter to
type A. On demand remove one or both adapters: e.g. to pull the cable through a conduit
or to connect a device with micro HDMI socket (type D). Do not change the adapters of
input and output side!
4. When needed unse the enclosed pulling sleeve (refer to separate manual).
5. Fix the pull wire (e.g. Kati®Blitz) at the pulling sleeve.
6. Pull the cable through the installation tube or cable conduit with reasonable care.
7. Afterwards remove the pulling sleeve carefully.
8. Make sure that signal source and playback device are switched off.
9. Connect the input side („Source") with the signal source and the output side („Display")
with the playback device.
10. Turn on the connected devices.
SPECIFICATIONS
HDMI standard:
HDMI® 2.0
max. resolution:
UHD 4K/60Hz (4:4:4), 18GBit/s
HDCP:
1.4/2.2
input and output:
HDMI plug type D (each with adapter
to HDMI plug type A)
wire:
combined fiber/copper cable
bending radius:
> 20mm
ambient temperature:
0°C - +50°C
plug typ D
Delivery includes:
hybrid cabel
pulling sleeve
Elektrik Handels GmbH & Co. KG • Am Ohrt 7 • D-59469 Ense-Höingen
Tel.: 0 29 38 - 98 76 20 • Fax: 0 29 38 - 98 76 22 2 • www.e-und-p.de
DISPOSAL INSTRUCTIONS acc. to ElektroG3
1. waste management of electronic and electrical equipment products
The symbol „crossed out dustbin" signifies that you are obliged to recycle these devices
separately from unsorted municipal solid waste. The disposal over domestic waste, e.g.
residual waste or yellow recycle bin, is forbidden. Avoid any bad throw by correct disposal
at specific collecting points.
2. extraction of batteries and lamps
Any batteries, accumulators or lamps which can be removed nondestructively from the
legacy device must be cleared from before disposal and must be disposed separately as
batteries or lamps.
3. return possibilities of legacy devices
Legacy devices can be submitted free at the public possibilities for return or collection. A proper
disposal of the equipment is esured in this way. Under certain conditions a return to a retailer is
also possible.
4. WEEE registration number
We are registered at the stiftung EAR, Nordostpark 72, 90411 Nürnberg as a distributer of electro-
nic and electrical equipment products by the registration number DE72183678.
WEEE-Richtlinie: 2002/96/EG
WEEE-Nr.:
DE72183678
MISCELLANEOUS
Declaration of Conformity
With the CE sign e+p Elektrik Handels GmbH & Co. KG ensures, that this
product correspond to the standards and directives of the European regulations.
The warranty for this product does only covert he product itself. The manufacturer is not
liable for damages to persons or property damage caused by improper installation, ope-
ration or maintenance. If any damage or fault is detected on your product, please contact
your local specialist dealer.
All rights for misprints, technical changes of product, packaging or documentation reseved.
2x HDMI®-adapter
installation guide
HDMI®
- adapter
Werbung
