Technical Data; Safety Advice - fontastic Renz10 Bedienungsanleitung

GB
Charge devices using the power bank
To charge devices via the powerbank, connect the
device to be charged to a USB cable and connect it to
one of the USB-A ports (3,5) or the USB Type-C port (4)
of the power bank. The charging process will start.
Disconnect the cable from the power bank after use.
Note: When using USB ports at the same time, the
available current will be shared.
Consult the device manual to determine the power
consumption required.
Note: If there is short circuit while charging a
device, the power bank will turn off.
Plug the micro-USB cable into the power bank
Micro-USB input, and connect the USB plug on the
cable to a USB charger or computer. A short charge
pulse is sufficient to reactivate the power bank.
5
In case you need technical support, please contact our
support-team by e-mail under service@fontastic.eu.

Technical data:

• Capacity: 10.000 mAh 37 Wh / 3.7V
• Input Micro USB/Type-C: 5.0V DC 2.0A
• Output USB-A1: 5.0V DC 2.0A
• Output USB-A2: 5.0V DC 2.0A
• Output Type-C: 5.0V DC 2.0A
• Total Power: 5.0V DC 2.0A 10W
• LED Charge level indicator
• Dimensions: 136 x 68 x 15 mm
• Weight: 215g

Safety advice:

• Do not open the device.
• Do not hold the device under water.
• Keep it safe from humidity.
• Do not connect the power output to the power input or
vice versa.