Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mounting of blade
1. Loosen the screws on the blade holder with the sup-
plied Inhex wrench.
2. Position the blade so that it is in place.
Tighten the screws again with the inhex key without
over-tightening.
Parts
A: Stepless thermostat knob
B: Spring loaded safety trigger
C: Hanger
D: Blade holder
E: Auxiliary presser foot
Groover installation
1 Shape the bending
blade to the form you
want
3 Set screws after
installation of the
shaped blade
2 Put the shaped
blade into the
groover
4 Insert the mounted
groover into the Heat
Knife
Werbung
