Remote Control; Maintenance; Cleaning - STENDA 1500 Bedienungsanleitung

Remote control

1. On / Off. Switches on or off the heater or stands it by.
2. First gear. After turn on the heater, you can choose low heating.
3. Second gear. After turn on the heater, you can choose moderate heating.
4. Third gear. After turn on the heater, you can choose high heating.

Maintenance

Attention! Careful and regular maintenance of Infrared Heater is required to attain a long and
efficient operation of your appliance.
1. Check the cleanliness of the Reflector and IR-Filament at least once a month. If necessary,
apply cleaning and maintenance instructions.
2. The number of checks may be increased considering the amount of the dust in the
environment.
3. Check the deformation of the Reflector, Wire and Frame visually while cleaning the
appliance. In case of any deformation, consult a qualified technician.
4. Check the power cable and plug visually while cleaning the appliance. In case of any
deformation, consult a qualified technician.
5. It is recommended to change the reflector every 2 years for more efficient operation.

Cleaning

Attention! Regular and careful cleaning helps your heater operate for longer years and more
efficiently.
1. Unplug your power cable for your safety before cleaning your appliance.
2. Take out the front grid wire through the inlets on the frame using a slotted screwdriver.
3. Make sure that the power is off for your safety. Power cable plug must be unplugged.
4. The reflector and filament must be cleaned with a soft cloth, a smooth brush or cool or dry
air. The cloth may be damp but never too wet and the cleaner should not include any
chemical.
5. Refrain from using cleaning material likely to damage the reflector (cleanser etc.).
6. Insert the wire grid using a slotted screwdriver.
15