Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Bedienungsanleitung
EN
X-table: As an accessory to the Xbrick, I help you
build a table in no time. Just assemble it and sit
down!
Here are the most important facts and figures as
well as instructions for use - what you can do with
me without any problems and what you should avo-
id.
Facts and Figures
•
Material: spruce 3-layer board with bump
edges
•
Surface: matt lacquered
•
Measurement: Table top: 1800x900x19 mm
Clamping bars: 1500x500x19mm
•
Construction: to plug in
Please note when using it:
The X-table should be used together with at least
four Xbrick, two X-connectors and two X-belt.
To avoid the risk of tipping, please note that I am
a lightweight construction and pay attention to the
assembly instructions below.
How to assamble me?
Follow my short instructions for a safe and
quick installation.
1.
Plug two X-brick together with one
X-connector.
2.
Place X-table on the two Xbrick towers
so that the Xbrick are clamped bet-
ween the sides.
2a.
Make sure that the Xbrick is placed
between the two outer grip holes. Then
press the X-table completely onto the
Xbrick.
3.
Insert one X-belt through each of the
outer grip holes in the X-table and
through the grip holes of the lower
Xbrick. Close the belt strap and tighten
hand-tight.
4.
Add more Xbrick to the structure to
create different heights.
5.
To carry the table top, please use the
xbrick.eu
manual
Hello, I am your
1
3
X-table
65mm
2
4
~52cm
~77cm
~102cm
With different positions you can reach
even more heights
wd
wd
3
3
_ spatial design
_ spatial design
2a
5
02.2021
Werbung
