Operating Instructions - Rovary Rv2000P Betriebsanleitung

Operating instructions

1. When you take the device out of the box for the first time, connect it to the USB cable provided.
2. To turn on the CO2 meter, press the pin as shown in the photo. The pin should remain pressed.
3. When the meter is successfully connected, the power indicator and the 3 LEDs will blink one after
the other, one by one.
4. The main display will show a countdown from 10, the meter is ready to use. No initial setup or
calibration is required.
5. The Rovary RV2000P meter is rechargeable and can also be used without a cable.
Please note! Make sure that
the pin is fully pushed in
otherwise the meter will not work.
4
Manual EN