Kiepe Zero Estremo Evo Bedienungsanleitung Seite 9

1. ON-OFF switch
2. Clip-on comb
1
HOW TO USE
1. Apply oil to the cutting blades before
using the device for the first time.
2. Connect to the power outlet.
3. Turn on the clipper by ON/OFF switch.
4. Please only use the correct oil, apply the
oil to the blades after each time use.
Note: An audible click may sometimes be
heard when switching the equipment on,
it is a result of the drive unit switching on.
This is completely normal.
3. Oil the blades
4. Change and fix the blades
2 3
HOW TO CHANGE THE BLADES
Switch off the clipper and disconnect it
from the power outlet.
Undo both screws on the cutting set, re-
move the bottom blade and the top blade.
When assembling, the bottom blade and
top blade should be aligned as follows:
1. Adjust the cutting-length adjustment
lever to the shortest cutting length.
2. The distance between the front edge of
the bottom blade and the front edge of the
top blade should be between 0.8mm and
1.5mm.
3. The bottom blade and the top blade
should be parallel to each other.
4. The first tooth of the top blade (from
the left) must cover the first tooth of the
bottom blade.
5. The outermost tooth of the top blade (on
the right) must touch the outermost large
tooth of the bottom blade (on the right).
6. Tighten both screws.
4
9