Fcc Information; Declaration Of Conformity - Macwheel MX1 Handbuch

end-of-life is to dispose of the entire unit at or through a MACWHEEL recycling center, program, or
facility. Local regulations and laws pertaining to the recycling and disposal of lithium-ion batteries and/or
products containing them will vary according to country, state, and local governments.
You must check laws and regulations corresponding to where you live in order to dispose of the battery
and/or unit properly. It is the user's responsibility to dispose of their waste equipment properly in
accordance with local regulations and laws.
For additional information about where you should drop off your batteries and electrical or electronic
waste, please contact your local or regional waste management office, your household waste disposal
service, or your point-of-sale.
1.3

FCC Information

DECLARATION OF CONFORMITY

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC RELATED INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequen-
cy energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
●
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and receiver.
●
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
●
Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment
- 02 -