Werbung
WARNING
FAILURE TO FOLLOW THESE WARNINGS AND INSTRUCTIONS
COULD RESULT IN SERIOUS INJURY OR DEATH
BE AWARE OF THE RISK OF OPEN FIRE AND OTHER SOURCES OF STRONG HEAT, SUCH
џ
AS ELECTRIC BAR FIRES, GAS FIRES, ETC. IN THE NEAR VICINITY OF THE COT.
DO NOT USE THE COT IF ANY PART IS BROKEN, TORN OR MISSING AND USE ONLY
џ
SPARE PARTS APPROVED BY THE MANUFACTURER.
DO NOT LEAVE ANYTHING IN THE COT OR PLACE THE COT CLOSE TO ANOTHER
џ
PRODUCT, WHICH CAN PROVIDE CAPTURE OF ARMS OR LEGS, CLAMPING OR
SUFFOCATION, EX.: STRINGS, BLIND/CURTAIN CORDS, ETC.
DO NOT USE MORE THAN ONE MATTRESS IN THE COT.
џ
A COT IS READY FOR USE, ONLY WHEN THE LOCKING MECHANISMS ARE ENGAGED;
џ
CHECK CAREFULLY THAT THEY ARE FULLY ENGAGED BEFORE USING THE FOLDING
COT.
IF THE HEIGHT OF THE COT BASE IS ADJUSTABLE THE LOWEST POSITION IS THE
џ
SAFEST AND THE BASE SHOULD ALWAYS BE USED IN THAT POSITION AS SOON AS THE
BABY IS OLD ENOUGH TO SIT UP WHEN MOVABLE SIDES ARE PROVIDED, DON'T LEAVE
THE CHILD UNATTENDED IN THE COT; ALWAYS MAKE SURE THAT THE MOVABLE SIDE IS
CLOSED.
WHERE DETACHABLE SUPPORT RAILS ARE PROVIDED TO SUPPORT THE COT BASE
џ
ABOVE ITS LOWEST POSITION IT IS ESSENTIAL TO REMOVE THESE RAILS BEFORE THE
COT IS USED IN ITS LOWEST POSITION.
ASSEMBLY DRAWING, A LIST AND DESCRIPTION OF ALL PARTS AND TOOLS REQUIRED
џ
FOR ASSEMBLY AND A DIAGRAM OF THE BOLTS AND OTHER FASTENINGS REQUIRED.
THICKNESS OF THE MATTRESS SHALL BE SUCH THAT THE INTERNAL HEIGHT (SURFACE
џ
OF THE MATTRESS TO THE UPPER EDGE OF THE COT FRAME) IS AT LEAST 500 MM IN
THE LOWEST POSITION OF THE COT BASE AND AT LEAST 200 MM IN THE HIGHEST
POSITION OF THE COT BASE.
IT'S RECOMMENDED TO KEEP THE FURNITURE IN A STABLE ENVIRONMENT WHERE THE
џ
TEMPERATURE IS NOT LESS THAN 15 DEGREES C WITH THE RELATIVE HUMIDITY IN THE
50 - 55%
RANGE. AFTER ASSEMBLY, MAKE SURE THAT ALL SCREWS ARE TIGHT.
џ
EVERY G MONTHS CHECK ALL LOCKING MECHANISMS, IF NECESSARY TIGHTEN
џ
LOOSE SCREWS;
FOLLOW THIS RULE TO PREVENT THE OCCURRENCE OF SQUEAKS.
џ
IN CASE OF OCCURRENCE OF SQUEAKS DISASSEMBLE THE COT AND WIPE THE
џ
STABBING PARTS
WITH A DAMP CLOTH AND ALLOW DRYING.
џ
THEN ASSEMBLE THE COT, CHANGE THE POSITION OF THE SIDE PANELS.
џ
MAKE SURE ALL SCREWS ARE TIGHT.
џ
MAINTENANCE
EN 716: 2008
3
Werbung
