JRS Eco 05AC Gebrauchsanweisung Seite 11

If the 5GHz network is not showing on your wireless device
– In the menu Advanced –> Wireless, change the country setting, if available, for the 5GHz
network, to the correct value.
I can connect to the eco-wifi network but cannot get on the internet
How to identify this problem? Connect with the eco-wifi network, either hardwired through
one of the LAN ports of the eco-wifi, or wireless, then type
bar of your browser, log in (standard username 'root', password 'ecowifi!') and click on
'Status'. The screen shows 'WAN - Status Renewing... ' like this:
This means that there is a cable connected to the WAN port, but your internet modem fails to
provide an IP address to the eco-wifi router.
Solution 1: Your internet modem may be configured in so-called Bridge Mode. Whatever
router or other device you connect to its LAN port is then directly connected to the provider's
network. Often only one unique device (MAC adress) is allowed to be connected to the
provider's network. When this place has been taken by by the previous setup, the network
needs to be reset. Try to turn off your internet modem for a full five minutes. Then turn
back on and reconnect the eco-wifi router to LAN port 1 of your internet modem. You may
also contact your internet provider's customer service for assistance.
Solution 2: Alternatively you may need to check whether the connection between the eco-wifi
router and the internet modem is properly made. The ethernet cable should run to a port
labelled 'LAN' on the internet modem, preferably port no. 1. See the figure at the start of this
manual.
Gv J. v. Stolbergln 31 - A3850
2263AB Leidschendam
The Netherlands
+31 85 25 00 235
www.jrseco.com
info@ jrs eco.com
11
Copyright 2018 JRS Eco Wireless – 05AC V4
http://192.168.4.1 in the address