PULCHER A16P 3/8 Montage Und Einstellung

PULCHER A16P 3/8
SIDE INLET FILLING VALVE
METAL THREAD
TECHNICAL PARAMETERS:
GB
1. working Pressures: 0,05 - 1 MPa
2. working Temperatures: 5 - 40°C
DESCRIPTION OF FUNCTION:
The valve is used for the automatic filling of a WC tank with
water. It works on a hydraulic principle of differences between
surfaces. When the Lever N082 is raised by Float N084, found
over the Regulating Thread N085, the nozzle on enclosure N081
is closed, this increasing the water pressure on the membrane
N009. This pressure pushes the membrane into the recess of valve
N077(N078,N079) and closes the outlet. When the water level
falls in the WC tank, the float falls down the regulating thread, and
the lever opens the nozzle. As the pressure above the membrane
lowers,the valve opens and water begins filling the tank.
ASSEMBLY AND ADJUSTMENT:
If possible, the valve should be installed in a horizontal position,
with the outlet pipe in a perpendicular position, attached to the
cistern wall by nut N016 (N023). The water level in the cistern is
adjusted by the height of float N084, aided by regulating thread
N085. Insert plastic Filter N125 in the inlet part of valve body, to
catch water impurities. For easy removal, the filter is attached
with a stem. The assembly thread of valve G1/2" (G3/8") is ad-
justed for connecting to common water pipes.
NOTICE FOR USERS:
After you have installed the valve, you may notice a small vibra-
tion.Do not be alarmed, this is normal and will disappear gradually
once the air is bled through the valve. Poor performance of the
valve can occur due to clogging of the Filter N125, in which case
you should remove and clean it. This is why we do not recom-
mend, especially in domestic plumbing, water supplies with small
impurities. Calcium stones from blocked parts can easily be re-
moved by soaking the Filter in a 5% Common Vinegar solution for
1÷1,5 hours. Regular maintenance is recommended to ensure the
valve remains in good working order,as shown in the drawings.
Only original manufacturers parts should be used during repair or
maintenance, and these are available from your local retailer. In
the event of any problems, please contact a qualified professional.
www.pulcher-design.com