Ethernet Connection; Factory Reset Button; On/Off Button - Technetix G.hn Powerline Wi-Fi Bedienungsanleitung

Ethernet
connection
Connect the CAT6
patch cable here for

Ethernet connection.

Power LED
Flashing LED:
device is trying to
establish a link with
another unit.
LINK LED
Flashing LED:
Traffic being sent over
the Powerline network.
Wi-Fi-LED
Fast flashing LED:
traffic over Wi-Fi .
Slowly flashing LED:
WPS is in progress.
LED turns red:
WPS has failed.

Factory reset button

Press for 10 seconds to
reset the Powerline link.
Press for 15 seconds to
reset the Wi-Fi
configuration.

1. On/off button

Power off the unit
(settings will be saved).
2. Link Button
Press for 3 seconds.
Unit will try for up to
120 seconds to establish
a link with another unit.
3. Wi-Fi protected
setup (WPS) button
Press once. Unit will allow
one device access to the
encrypted network without
physically entering the
password. For example:
Select the Technetix Wi-Fi
network on your phone or
laptop, press the Wi-Fi WPS
button at the same time as
entering the password on
your phone or laptop (this
will not work on all devices
for safety reasons).
1.
2.
3.