Mounting Material - Hornbach 10476778 Gebrauchsanweisung

Mounting material

A fully closed pergola awning has to be able to with-
stand extreme loads at its fastenings. Depending on
the wall type at the installation site, the correct fas-
tening must be selected in order to ensure a secure
fixation. The table below provides a basic recommen-
dation of fastenings for different wall types, but a spe-
cialist should be consulted in order to figure out which
fastening is the appropriate one. He will also be able
to inform about the wind resistance class the awning
can withstand after the installation.
WALL TYPE
Concrete
Concrete / C20-C25
Solid brick
Clay brick / MZ
Sand-lime brick / KS
Perforated brick
Clay brick / HLZ
Sand-lime brick / KSL
Aerated concrete
Gas concrete / PB2
Cavity wall
For every mounting material, the specifications of the fastening manufacturer must be observed, e.g. drill
sizes, distances to edges, tensioning torques, drying times etc.
208 | ENGLISH
LOCATION
Wall
Wall / insulated
Wall
Wall / insulated
Wall
Wall / insulated
Wall
Wall / insulated
Wall / insulated
WARNING
WARNING
To meet the wind resistance class mentioned in
the declaration of conformity, the installed awning
needs to fulfil these requirements:
•
The retractable screen is installed with the rec-
ommended type and number of brackets.
•
The pergola awning is installed under considera-
tion of the given fastening pull-out forces.
•
The instructions of the fastening manufacturer
have been respected during installation.
The combination of wall type and mounting mate-
rial used at your installation site might result in a
lower wind resistance class for your retractable
screen.
FASTENING
e.g. TOX Anchor bolt S-Fix Pro 1 A4
e.g. TOX Thermo Proof Plus
e.g. TOX Masonry Set Wallix
e.g. TOX Thermo Proof Plus
e.g. TOX Masonry Set Wallix
e.g. TOX Thermo Proof Plus
e.g. TOX Mosorny Set Wallix
e.g. TOX Thermo Proof Plus
e.g. TOX Thermo Proof Plus