Kemper Figur 620 Montage- Und Bedienungsanleitung Seite 29

Safety instructions
for installation, maintenance and operation
The descriptions and instructions in these
operating instructions are about the leak control
and the facilities for additional applications. The
prerequisite for operating the controller is the
deployment of professionally trained personnel
(see EN 50 110-1, in the ELT area as well as drin-
king water installations in accordance with TRWI
DIN 1988).
If you cannot find all required information and
instructions in these operating instructions, please
ask the manufacturer, Gebr. Kemper (address, see
last page) to exclude any malfunctions.
If the operating instructions are not followed, the
manufacturer of the leak protection system does
not bear any responsibility/warrant any guarantee.
This safety data sheet contains basic instructions
that must be complied with during set-up, commis-
sioning and maintenance. Therefore, the mechanic
and the responsible specialists/operators must
read these operating instructions before assembly,
installation and commissioning. Chapters 1 to 5
must be thoroughly read to ensure the reliability of
the leak protection system.
Before commissioning, make sure the drinking
water and electrical installation has been made
professionally:
• the connections were made properly and
professionally and
• the plant is professionally protected.
Follow all applicable regulations (ELT, SAN...) and
the regulations from the local utilities.
Unauthorized alteration and spare part
fabrication
Alterations and modifications to the device are
only permissible after consultation with the
manufacturer. Genuine spare parts and accessories
authorized by the manufacturer serve safety. The
use of self-procured electronic or drinking water
installation components can result in invalidation
of the liability of the manufacturer for the resulting
consequences.
Unauthorized methods of operation
The operational safety of the supplied device is
only ensured when used as intended. The tolerance
values stated in the documentation (see Technical
Data Chapters 2 and 3) must never be exceeded in
any cases.
Do not use the product for other purposes than
described above.
Only use the Leak Protection System
• in sound condition
• as intended
Disposal
Local regulations on waste
recycling and disposal must
be followed. The product
must not be disposed of with
household waste but must
rather be disposed of
appropriately.
© www.kemper-olpe.de – 04.2022 / KK410062000000-00 – 29 /72