Vinsetto 920-071V90 Betriebshandbuch Seite 13

Step 5:
6.1 As shown in Figure 1, insert the hexagonal bar into the table leg B until the buckle is not
visible.
6.2 Assemble the other end of the connecting rod to the table leg A and screw on the handle.
The handle does not need to be tightened.
Note: As shown in Figure 2 below, it needs to be aligned with the card slot.
6.3 Pull the connecting rod with the handle to the bottom end of the table leg A in the direction
of the arrow as follows.
6.4 Tighten the handle and install the M4 screws.M4 screws using the supplied screwdriver .
N
K
2
6.5 Conect the power cord and motor of the power supply handest as show in the figure.
I I I
3 2 1
N
2
Tightened
K
1
3
2
I
3
I
2
I
1