Setting Up The Tent; Fitting The Side Walls - Partyspace FLEXXUM Anleitung

EN 12

SETTING UP THE TENT

1. With two people, hold the centre of the scissor element on the short side of the f rame and
walk further backwards. Pull the tent fully open. With the larger sizes (3 x 6, 4 x 6 and 4 x
8) it can sometimes be slightly more diff icult to click the roof f rame together. In that case,
it is advisable to push the tent upwards beneath the central pole(s).
2. Place your foot on the baseplate and push the roof f rame for each leg up until it clicks into
place.
3. Push the tension straps on the inside of the roof through the square opening and secure
them. Tension the straps tightly.
4. With two people, lift one side of the tent up and pull on the pin near the bottom of the legs.
Slide the legs out until you hear a click. Do this either on one short side or one long side of
the tent, but never with two diagonally opposite legs.
5. Repeat step 4 on the other side of the tent.
1.
3.
FLEXXUM - MANUAL
2.
4.
13 FLEXXUM - MANUAL

FITTING THE SIDE WALLS

1. Attach the flaps on one side of the f irst side wall f rom top to bottom to a leg. The opening
in the canvas goes around the pin of the leg.
2. Aff ix the Velcro at the top of the side wall to the inside of the roof. Begin on the side where
the side wall has already been attached to the leg.
3. Attach the flaps on the other side of the side wall f rom top to bottom.
4. Aff ix the flaps on one side of the second side wall to the rear of the side wall already f itted.
5. Aff ix the Velcro at the top of the side wall to the inside of the roof. Begin on the side where
the side wall has already been attached to the previous one.
6. Repeat step 3. Attach all the side walls in the same way.
1.
3.
2.
EN