Audio Pro Business SUB-3 Bedienungsanleitung Seite 8

WIRELESS + WIRED INSTALLATION
COMBINE WIRELESS WITH WIRED TRANSMISSION
1. System must be wireless from source with TX-1 and to at least one speaker or subwoofer.
2. Speaker receiving wireless signal has input set to WIRELESS.
3. From speaker receiving wireless signal, connect balanced cable to LINE OUT.
4. Set input to WIRED on speaker receiving signal by cable, and connect cable to LINE IN.
Continue this set-up for all speakers using wired signal.
NOTE:
• Number of speakers added in a WIRED chain is infinite.
• Volume Zone and volume level set on the speaker receiving wireless signal will effect speakers connected by cable.
Set speaker (receiving WIRED signal) volume control to 0 to have same level.
• When set to WIRED input, volume level on wired speaker can be adjusted -20 dB to +20 dB to fine tune volume levels
on that specific speaker.
1. Wireless / Wired input switch
2. Line in, + / Ground / -
3. Line out, + / Ground / -
REAR OF SP-1, SP-3
8
3
2
1
REAR OF SUB-1, SUB-3
1
2 3