Herunterladen Diese Seite drucken

SunPower SPS-225P-Serie Betriebsanleitung Und Sicherheitsinformationen Seite 2

Werbung

SPS-225P-xx Series
225W, Single Output
Active P.F.C Function
Features:
* Altitude during operation up to 16404ft ( 5000m )
* Universal AC input with active PFC circuit, P.F.>0.95
* Power ON with LED indicator
* Built in EMI filter, low ripple noise
* Over voltage、over load & short circuit protection
* Output voltage ± 10% adjustment
* Output voltage remote sense
Specification:
Voltage
Frequency
Current
INPUT
Inrush Current(TYP.)
Leakage Current
Power Factor
MODEL No.
Voltage
Min Load
Max Load
OUTPUT
Output Tolerance
Ripple Noise MAX.
Efficiency (TYP.)
Output MAX.
Over Voltage
PROTECTION
Over Load & Short Circuit
Rise time
Hold up time
ELEC. CHAR.
Setup time (TYP)
Remote sensing
Remote Control
Temperature
ENVIRONMENT
Humidity
Withstand voltage
SAFETY
Isolation resistance
Safety standard
EMI
EMC
EMS
Cooling
M.T.B.F.
OTHERS
Dimension
Packing
All measurements which not mentioned are based on 230VAC input, output Max at ambient 25℃ / 70%RH
Output tolerance included set up voltage, line regulation and load regulation.
Ripple & noise are measured at 100〜254VAC input with 10〜50℃ condition and 20MHz of bandwidth by using a 10〞〜15〞twisted pair-wire terminated
with a 0.1uF & a 47uF parallel capacitor.
NOTE
The operating temperature shall follow the de-rating curve in spec
The output load may be requested for decreasing as de-rating curve in spec when low input voltage is under 100VAC.
The power supply is considered a component of end-equipment. The end-equipment must be re-confirmed whether comply with EMC directives.
Copy Right Sunpower Technology Corp. 2009, All Rights Reserved.
Specifications subject to change without notice.
QR0405-1 Rev,:1.0
85V ~ 264VAC universal full range or 120V ~ 375VDC.
47 ---- 63 Hz
<3A @100V AC input, full load condition
35A@115V , 70A@230V AC input. Cold start at 25℃ ambient
<1.5mA@264V AC input
PF > 0.95
SPS-225P-05 SPS-225P-12 SPS-225P-15 SPS-225P-24 SPS-225P-27 SPS-225P-30 SPS-225P-48
5V
12V
0A
0A
40A
18.8A
±2%
±1%
150mV
150mV
85%
89%
200W
225.6W
5.8V~7.0V
13.8V~16.8V
Shutdown and latch off, recover after re-start up.
When power supply over 105%~ 150% max load or short circuit acted, power supply will be c
and recover automatically after the fault is removed.
limiting
<20mS
>16mS@230V, full load condition
<3.0S@115VAC , <1.5S@230VAC
(RS+, RS-).
RC+/RC-: Standard Type 0~0.8V= Power On; 4~10V= Power Off;Reverse Type 0~0.8V= Power Off; 4~10V= Power On
Operating: -20 ~ +70℃ ; De-rating: 45 ~ 70℃: 2.5%/℃ ; Storage: -40 ~ +85℃
Operating: 20% ~ 90% RH (non condensing) ; Storage: 10% ~ 95% RH (non condensing)
I/P-O/P:3KVAC, I/P-FG:1.8KVAC, O/P-FG:0.5KVAC, 1minute
I/P-O/P, I/P-FG, O/P-FG >100MΩ/500VDC at 25℃/ 70% RH
nd
UL 62368-1, 2
Edition, 2014-12-01, CAN/CSA C22.2 No.62368-1-14, 2
Test Items
Conducted
Radiated
Harmonic
Voltage Flicker
Test Items
ESD
Radiated
EFT / Burst
Surge
Conducted
Magnetic Field
Voltage Dips and Interruptions
Natural cooling
148.7 K hours
198 x 99 x 38 ㎜ (L*W*H)
N.W.: 0.647Kg / 1pc; 18 pcs / 1.38 CUFT / 1 CTN
SUNPOWER TECHNOLOGY CORP.
16F.-1, No.150, Jian 1st Rd., Zhonghe Dist., New Taipei City 235, Taiwan (R.O.C.).
TEL: 886-2-8226-3100
FAX: 886-2-8226-3111
http://www.sunpower.com.tw
E-mail: sunpower@sunpower.com.tw
* Remote control ON/OFF Type Optional:
①Standard Type SPS-225P-xx
②Reverse Type SPS-225P-xxR (has MOQ required)
* UL, cUL, CB, CE approved
* 3 years warranty
15V
24V
0A
0A
15A
9.4A
±1%
±1%
150mV
200mV
89%
89%
225W
225.6W
17.3V~21.0V
27.6V~33.6V
Standard
EN 55032
EN 55032
EN 61000-3-2
EN 61000-3-3
Standard
EN 61000-4-2
EN 61000-4-3
EN 61000-4-4
EN 61000-4-5
EN 61000-4-6
EN 61000-4-8
EN 61000-4-11
198 x 99 x 38 mm
7.8 x 3.9 x 1.5 inch
30V
27V
0A
0A
8.4A
7.5A
±1%
±1%
200mV
250mV
89%
89%
226.8W
225W
31.1V~37.8V
34.5V~42.0V
nd
Edition, 2014-12, IEC 62368-1:2014
Test Level
Class B
Class B
Class D
---
Test Level
Level 3, 8KV air;Level 2, 4KV contact
Level 2, 3V/m
Level 2, 1KV
Level 3, 2KV/Line-Eatth , 1KV/Line-Line
Level 2, 3V
Level 2, 3A/m
>95% dip 0.5 period, 30% dip 25 periods
>95% interruptions 250 periods
SPS-225P-xx Rev 1.1
RS-190013 JUL-28-2021
C B
48V
0A
4.7A
±1%
250mV
90%
225.6W
55.2V~67.2V
onstant current

Werbung

loading

Diese Anleitung auch für:

Sps-225p-05Sps-225p-12Sps-225p-15Sps-225p-24Sps-225p-27Sps-225p-30 ... Alle anzeigen