Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
Intended Use
The pool lights serve as a decorative light for use underwater or in areas
exposed to splashing water. The supplied remote control can be used to
regulate the intensity and colour of the light.
In addition, the lights are equipped with a timer that switches the lights off
after a specified period of time.
Assembling and Setting up
Before using the device, insert the batteries as described below. Also, pull the
insulating strip out of the remote control. Install the lights in a suitable location
in the pool. Suction cups and built-in magnets are available for attachment.
When using the magnets, unhook the suction cups from the mounting holes
and remove them from the lights.
Operation
Use the remote control to operate the pool lights. Please note that the remote
control is not waterproof. The LED on the remote control indicates that the
radio transmitter in the remote control is active. The lights are switched on
and off with the ON (1) and OFF (5) buttons. Use the up and down buttons (2)
to dim the lights. With the RGB buttons (3) set the basic colours and the colour
change buttons (11) regulate the colour transitions in operation.
The type of colour transitions is controlled with the FADE (7) buttons (the lamp
fades in the transitions and lights up again in the new colour), FLASH (8) (hard
colour transition) and SMOOTH (10) (soft colour transition). The LEDs are set to
white with the W button (9).
With the buttons (4) you regulate the running time of the timer. The timer
starts the lamp again for the set time 24 hours after the timer has been
activated. After activating the timer, the light flashes once for each hour set as
confirmation. You can check the timer setting during operation by pressing the
ON button. The light then flashes once for each hour set.
The timer function remains active until the timer is switched off with the TIME
OFF key (6).
8
Werbung
Inhaltsverzeichnis
