Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Inserting a Glue Stick
Insert one glue stick 100 x 7 mm into the rear end of the glue gun and push it in
as far as you can. Press the trigger to make sure that the stick is solidly pressed
against the heater unit.
Operation
1. Connect the unit to a power outlet and set the glue gun on its wire support.
The glue gun heats up with a power of 10 W and then shifts to a heat
holding mode of 7 W. Wait until some glue is molten and appears in the
nozzle. When the trigger is pressed molten glue is forced out of the nozzle.
If you interrupt your work for longer than a few minutes, pull the power
cord.
2. Put some molten glue onto the dry, clean surface you want to use and
immediately press the work piece you want to glue down into the molten
glue. The glue solidifies almost immediately and forms an instant bond.
Press the glued parts together for several seconds.
3. When the stick cannot be pushed any further by the trigger, put in a new
stick. The old stick remains in the gun until it has been completely melted
when using the unit next time.
Cleaning and Storing
▪ Before working on the tool, disconnect the plug from the power.
▪ Clean the device only with a lightly dampened cloth. Never immerse it in or
spray it with water or liquids of any kind.
Technical Data
Nominal Voltage:
Nominal Power:
Protection Class:
Dimensions:
Weight:
Pre-Heating Time:
Glue Flow:
Glue Stick:
Operation
230 V, 50 Hz
10 W / 7 W
II
11 x 13 x 3 cm
120 g
5 – 7 min
9 – 12 g/min
100 x 7 mm
6
Werbung
Inhaltsverzeichnis
