The heater must be installed on at least 1.8M from the ground and 50cm from the side wall.
2.
Drill 2 holes on the ceiling or wall according to the size as table showed above. Insert the 2 Expansion Bolts into the holes. Use a spanner to twist the
Screw Nuts on the Expansion Bolts clockwise till they are securely located in the holes. Unscrew the Screw Nuts and put them aside with Washers,
Spring Washers for further use later.
3.
Put Upper L Bracket onto the ceiling or wall. Let the 2 Expansion Bolts go through the holes on Upper L Brackets and fix them with the Washers, Spring
Washers and Screw Nut above mentioned.
4.
Put Lower L Bracket onto the rear side of the heater. Fix them with screws M6*8 using the provided allen key.
5.
Mount Upper L Bracket on Lower L Bracket. Screw it tightly with Screw M6*16. For wall-mounted installation, make sure the control box is on the left
side.
6.
Loose the Screw M6*16, set the heater to a desired angle and drive the Screws M6*16 tight. The adjustable angle is within 60 degree totally.