Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Features / Functions
•
High-performance 3 W LED with 240 lumen
•
Lamp range approx. 300 m at full power
•
3 performance levels
•
Maintenance-free 6 V / 4.5 Ah lead-gel battery
•
Charge status display
•
Swivel lamp head
•
Flashing function
•
Emergency light function
•
Incl. yellow diffusing plate
Function of the rotary switch
2
1
CHECK
1.
Battery status indicator
2.
Warning light function
3.
Power level 1 (100%)
4.
Power level 2 (70%)
5.
Power level 3 (30%)
6.
Off
Charging state indicator of the battery
1
1.
Battery is empty when LED „1" flashes red
2.
All LEDs „2" (red, yellow, green) are on when
charging is completed.
3.
The green LED „3" lights permanently when the
rechargeable battery is full.
Important note for the use of rechargeable
lead-gel batteries!
This work lamp contains a lead-gel rechargeab-
le battery. Defective lead-gel batteries must be
disposed as special waste.
Before initial use please charge for approx. 24
hours.
6
All manuals and user guides at all-guides.com
3
4
5
6
OFF
2
3
Lead-gel rechargeable batteries achieve their
longest life time if they are stored in full condition.
Reconnect the signal lamp to the charger after
use. The work lamp can remain connected to the
charger permanently.
The electronic charging switch ensures optimum
charging conditions. Thus the rechargeable battery
cannot be overcharged.
Emergency light function
In case of power failure the signal lamp switches on
automatically. To use this function follow below steps.
1.
Turn on lamp
2.
Select the required type of power level
3.
Connect charger with the wall charging base
4.
Connect charging adaptor with 230V power
socket – the lamp turns off
Simulation emergency light function
Remove the charging adaptor from the 230 V power
socket – the work lamp turns on automatically.
Electronic deep discharge protection
This work lamp is equipped with an electronic
deep discharge protection in order to protect the
rechargeable battery. This prolongs the lifetime of the
rechargeable battery and protects the environment.
Rechargeable battery
The lead-gel rechargeable battery of the work lamp
may be charges approx. 300 – 400 times. Use as
replacement only rechargeable batteries of the same
type.
Charging the battery
By wall charging base:
1.
Connect the 230 V-power supply with the
charging base.
2.
Connect the 230 V-power supply with a 230 V
mains socket.
3.
Slide the work lamp into the charger.
By 12 V-charging Socket on the lamp:
1.
Connect the 12 V-charging cable with the char-
ging socket on the work lamp.
2.
Connect the 12 V-charging cable with a 12
V-supply socket.
Werbung
Inhaltsverzeichnis
