Strong SRT ANT 30 Bedienungsanleitung Seite 2

4. Perform the channel scan. Please see the user manual of your Digital Terrestrial Receiver or Digital TV
for the operation instruction.
5. Check the signal quality. If you cannot get a good and stable reception, please try to put the antenna
at different position and try different directions.
4.1 To power the antenna with Digital Terrestrial Receiver
1. Turn on your TV set and turn on your Digital Terrestrial Receiver.
2. Press the "MENU" button on the remote control of your Digital Terrestrial Receiver. Check in the
Set-Up or Installation menu of your receiver to see if the antenna power is set to "ON". (Normally this
is indicated in the menu as ANT power, Ext Antenna power or Active antenna power. Refer to the user
manual of your Digital Terrestrial Receiver.)
3. Connect the IEC Male end to your receiver. Normally the input connector on your receiver is marked as
"ANT" (in) or as "RF" (in). Refer to the user manual of your Digital Terrestrial Receiver.
5.0 NOTICE
For best reception, please check the following conditions.
1. Keep the antenna away from sources of interference; keep the antenna away from high power
consumption devices such as air conditioner, elevator, hair dryer and microwave oven etc.
2. Install the antenna as high as possible; in case of digital terrestrial reception, if there is any interruption
between the antenna and the transmission tower, it will cause signal loss. Avoid any interruption for
best reception.
3. Place the antenna near windows when using the antenna in indoor environment. If the screen or film
of windows is made of metal material, it will act as signal shielding. Place the antenna away from such
material.
6.0 TROUBLE SHOOTING
If you cannot receive digital programmes as you expect, please check the following conditions:
1. Check the connection. Make sure all connections are correct.
2. If you placed the antenna near the TV panel, please try to move the antenna away from the TV panel.
Some panels may reduce the signal reception of the antenna.
3. Adjust the direction and position of the antenna to find the best reception angle.
Subject to alterations. In consequence of continuous research and development technical specifications, design and appearance of products may change. LTE is a
trademark of ETSI, all other product names are trademarks or registered trademarks of their respective owners.
© STRONG 2021. All rights reserved.
2
Coaxial Cable
Power Adaptor
(DC 12 V)
PART 1