E-MORE TV LIFT 650 Bedienungsanleitung Seite 13

S
Press button to enter. It will display
: Sets the lowest position height display.
:Sets a new minimum desk height
:Sets a new maximum desk height
If , or
is already set, please drive the table-frame to the previously set height to change the value.
Press UP or DOWN. It will display
to set the lowest height display, press
Press UP or DOWN ,It will display
to set a lowest height position, press
Press UP or DOWN ,It will display
to set a new highest height position, press
8.Factory use setting (
Factory use, please ignore this programming.
9. Factory use setting (
Factory use, please ignore this programming.
10. Setting bounce height (
S
Press button and hold for 3 seconds, handset display
.
Press UP or Down to display
S
Press button to enter. It will show the current bounce height.
Press UP or DOWN to get the bounce height. Press
11. Restore Factory Defaults (
S
Press button and hold for 3 seconds, handset display
.
Press UP or DOWN to display
S
Press to enter. It will display
S
Press to confirm, wait 2 seconds, it will display
12.Fatigue test mode (
Factory use, please ignore this programming.
, press UP or DOWN. It will display
S
, press button to enter. It will display the current lowest height. Press UP or DOWN
S
to confirm .
S
. Press button to enter. It will display the current lowest height. Press UP or DOWN
S
to confirm .
S
. Press button to enter. It will display the current highest height. Press UP or DOWN
S
to confirm .
)
)
)
.
)
.
and flash.
)
S
. Release button, press
S
to confirm, wait 2 seconds, it will display the current height.
S
. Release button, press
. Perform a reset as mentioned under troubleshooting.
E-MORE TV LIFT 650 / 1000
and .
S
button again to enter, it displays
S
button again to enter, it displays
13