weasy igloo8 Bedienungsanleitung Seite 11

PROBLEM
The compressor
works abnormally
with a buzzing noise
Water shortage
indicator light is on
Indicator lights on
display are not on
The Ice made is too
large and with pieces
sticking together.
The ice making
process was correct,
but no ice came out?
All indicators flash at
the same time.
The machine has
been working, but
the water has been
warming
When the ice is full,
the machine does
not display the ice
full Icon
1. If the power cord is damaged; it must be replaced by the manufacturer, its service agent or a similarly qualified
person in order to avoid a hazard.
2. Fill with potable water only.
3. It is normal for the compressor and condenser surface to reach temperatures between 70°C and 90°C during
operation and surrounding areas may be very hot.
4. Due to fast freezing, ice cubes may appear "Cloudy". This is air trapped in the water and will not affect quality or
taste of ice.
5. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities or lack of experience and knowledge unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
6. Children should be supervised to ensure that they do not play with the appliance.
7. Do not immerse in water.
POSSIBLE CAUSE
The voltage is lower
than
recommended
1.There is no water
2.The pump is full of air
Blown fuse/ No power
1.Ice of previous cycles
left in the water tray
1. The compressor has
no refrigerant
2. Compressor
damaged
3. Fan motor damaged
1. The water box is
blocked by ice.
2. The motor is stuck, or
the motor falls off, or the
motor is damaged
3. Micro switch
damaged
Solenoid broke down
Ice full sensor damaged
Solar light interference
SUGGESTED SOLUTIONS
Stop the Ice maker and do not
restart until the voltage is normal.
1.Add to some water until it
reaches MAX position
2.Press POWER button to restart
Replace fuse / Turn power on
1.Take out the ice under the
standby state
Call the service hotline
1. Take out the ice under the ice
shovel, plug in the power again,
and press the POWER button.
After 3 minutes, the machine will
restart automatically.
2. Call the service hotline
Replace the solenoid valve
1. Replace the ice full sensor
2. Move indoors to make ice
3. Call the service hotline