Tangent Danmark PowerAmpster II Bedienungsanleitung Seite 4

Connect your device as a Stereo amplifier:
1. Connect the power cord to the back of the
amplifier then connect it to a wall outlet.
2. Connect your preamplifier to Left/Right RCA (3) or XLR Output (4).
3. Turn the power button to the On position, after two seconds the unit will enter working
status and the standby indicator will lit up.
Connect your device as a Mono amplifier:
1. Connect the power cord to the back of the
amplifier then connect it to a wall outlet.
2. Connect your preamplifiers Left output to Left RCA (3) or Left XLR Output (4).
3. Connect speaker cables to the connectors marked BRIDGE MODE - & +
4. Switch the Stereo/Mono switch to mono.
5. Turn the power button to the On position, after two seconds the unit will enter working
status and the standby indicator will lit up.
And do repeat the above for your preamplifier Right output to your second PowerAmpster II
Indicator Function
Power/Standby indicator
Power on: Push the power switch button on rear panel at "ON" position the LED indicator will turn on.
When the unit get audio signal it will automatically turn on. LED will be WHITE when the unit is active.
Standby:
The PowerAmpster II goes into auto standby when in-active in 15min, and it will wake up again when it
get input signal. LED will be RED when the unit is inactive.
Power off:
Push the power source button at "OFF" position, and unit will go into power off status.
(UK)