Blaupunkt VIO-B40 Schnellstartanleitung Seite 7

5. Installation
•
Check your WiFi signal strength and make sure that the WiFi signal is strong at
the location of your camera. For best performance, the smartphone needs to be
connected to a Wi-Fi network.
5.1. Micro SD installation (optional)
Locate the Micro SD-Card compartment of the camera. (refer to chapter 2 point
Install the Micro SD-Card into the indicated MicroSD-card slot.
NOTE: The Micro SD-Card is mandatory for local recording. Please make sure the
Micro SD-Card is CLASS10 rated. Supported are Micro SD-Cards from 8GB to 256GB.
5.2. Installation
Step 1:
• Find the desired installation place for the camera. position the camera where a power
socket is in sufficient proximity. Turn the camera ON and use the live view image from
the app to position the camera where everything to monitor is well in view.
Step 2:
• Place the camera on the desired position and mark the three needed drilling holes
with a pencil on the wall.
Step 3:
• Drill through the 3 small marked points.
Step 4:
• Drill a 20mm diameter hole for the Ethernet Network port and Camera Power
connector, if you want to pass both cable ports through the whole.
NOTE:
If due to special circumstances, such as a reinforced concrete wall, it's not possible
to drill a hole of 20mm diameter, you have the option to cut off the thick Ethernet
Network port - see "Chapter 2. Product Appearance", and seal it with a proper sealing
tape. With this option a 12mm diameter drill is needed.
Alert: If you decide to cut off the Ethernet Port, you will lose the possibility to connect
the camera by Ethernet cable to a router or NVR. Additionally, you lose your right of
return.
5
)
7