Advanced Features; Contact And Troubleshooting - KLIM ACE Benutzerhandbuch

Power saving function
In order to preserve battery life, the mouse sensor turns off
after 1 minute of inactivity while on a wireless connection and
the lights turn off after 3 minutes of inactivity. Press any
button to reactivate the mouse.
Tip: lowering the brightness or switching off the RGB lighting
completely significantly increases the battery life and reduces
the frequency of charges.
Note: while in wired mode, the mouse lights might stay on even
after the power is off due to the computer settings. If you
prefer them to be turned off, check your ERP settings
(advanced users only!), or contact our support team.

ADVANCED FEATURES

Polling Rate - press and hold the middle (3) and right (2)
buttons for 3 seconds to cycle through each Polling Rate
setting. The wheel light briefly flashes to indicate the current
setting: 1000 Hz (purple) - 500 Hz (green) - 250 Hz (blue).
DPI indicator - the logo on the mouse indicates the current DPI
level: 800 (red) / 1200 (green) / 2000 (blue) / 3200 (cyan) / 5000
(purple).
Press and hold the middle button (3), then press the back
button (6) to switch between the three available modes for the
logo light: always on, breathing, neon.
Side RGB lights - press and hold the middle button (3), then
click the forward button (5) to change the light effects.
Customization software
Access to advanced customization options such as mouse key
remapping, macros and multiple RGB effects and colors by
downloading the drivers at www.klimtechs.com/drivers.
Available for Windows only.
Important note for left-handed users: you may swap the side
button's functionality using these drivers to have forward/back
accessible from your left thumb.

CONTACT AND TROUBLESHOOTING

Do you need additional assistance with your product? Contact
us at support@klimtechnologies.com. Our team of specialists is
at your disposal and will always reply within 24 hours!
Problem
1. Fully charge the battery or try wired mode.
2. Ensure the switch under the mouse is in the
right position.
The mouse does
3. Make sure that the receiver is properly
not work
connected. Try plugging it to a different USB
port.
4. Contact our support team.
1. Check that there are no obstacles between
the USB receiver and the mouse. Try plugging
The cursor jitters
the receiver to a frontal USB port if available.
/ mouse stops
2. Move the mouse closer to the receiver.
working
3. Fully charge the battery.
momentarily
4. Place the mouse on a non-reflective surface
such as a mouse pad.
3
ENGLISH
Solution