Assembly/Disassembly; Adjustment - AmazonBasics B07V3QLZ5Y Bedienungsanleitung

5. Assembly/Disassembly

NOTICE
To disassemble the tool, follow the steps below in a
reverse order�
1� Place the blade (E) onto the base (H). The flat surface of the
blade has to face upwards. The blade adjustment slots (D) must
fit around the depth adjustment wheels (F).
2� Place the lever cap (C) on the blade (E).
3� Tighten the clamping screw (B)�
4� Tighten the blade screw (A)�
NOTICE
Do not over-tighten the clamping screw (B)�
It should be tightened enough to secure the blade (E) during
use� Turning the depth adjustment wheel (I) should be possible
without an excessive force�

6. Adjustment

NOTICE
» For creating an even workpiece surface, the blade's (E)
cutting edge (K) should be parallel to the mouth opening on
the sole (I)�
» If you want to achieve a side slope you can move one side of
the blade (E) out more than the other� In that case the side
protruding more from the mouth opening will cut deeper
into the workpiece surface�
EN
7