Adjusting The Brightness - Chacon 34272 Gebrauchsanweisung

3. Operating instructions
BUTTONS
At least 1.5sec. for
At least 1.5sec. to
Note: The CO2 concentration is 550ppm at start-up, please wait 30s for self-calibration
before using.
Note: When your device is plugged in, the temperature level is higher than normal.
4. Detector installation
There are two possibilities, either wall mounting or simply placing it on your furniture using the
integrated support foot.
Wall mounting:

5. Adjusting the brightness

To change your lighting, simply press the power/brightness button once (see diagram). You can
choose between 3 lighting levels.
ON MODE
LONG PRESS
switching off
decrease volume
1. Using a pencil and the magnetic wall plate, mark the drilling
points for better accuracy.
2. Add the dowels to the holes.
3. Place the mounting plate and tighten with the screws.
4. Place the Co2 sensor on the plate. The plate will stick magneti-
cally due to the built-in magnets.
SHORT PRESS
Brightness
adjustment
Mute or unmute
the alarm
OFF MODE
LONG PRESS
At least 1.6sec.
to switch on
No operation
SHORT PRESS
No operation
No operation